Vitavia greenhouse assembly instructions

ing of greenhouses. Please stick the greenhouse model label pro-vided onto the door bar (1362) after success-fully assembling this product. This information is important in the event that replacement parts are later required. Please keep these Assembly Instructions in a safe place, for future reference! Our policy is one of continuous improvement Assembly instructions Montageanleitung Montagevejledning Notice de Montage Monteringsanvisning Montasjeveiledning Kokoonpano-ohjeet 2 5 0 0 3 8 0 0 5 0 0 0 7 5 0 0 6 2 0 0 005.00.0802 Now position your greenhouse on the pre- pared base/foundation and connect loosely. Adjust the greenhouse until it is completely square and tighten all bolts. Please do not over tighten. (max. 3Nm) Press the end protectors (1017) and (1018) onto the profile ends (4.9). 5. DooR attention: Do not stand the assembled Assembly Instructions Before assembling your new greenhouse, please check that all parts in the provided list are included. Please take each bundle out of the packaging in order to identify the parts better. It is important that the opened bundles do not get mixed with one another. If something is missing please contact your retailer. This short clip demonstrates the key elements for assembling a Vitavia greenhouse base. The steel perimeter bases are available in powder coated grey, green Assembly instructions . 2 065.01.1411 • Contents / Symbols Page 2 • Recommendations Page 3 • Safety Notice Page 4 • Maintenance Page 5 • Part List Summary Page 6 Before beginning the assembly of your new greenhouse, please check that all parts in the following part lists are included. Please take each bundle out of the packaging ing of greenhouses. Please stick the greenhouse model label pro-vided onto the door bar (1362) after success-fully assembling this product. This information is important in the event that replacement parts are later required. Please keep these Assembly Instructions in a safe place, for future reference! Our policy is one of continuous improvement Bend the ends of the anchor legs to provide a secure connection in the concrete. Position the completed base on the prepared foundation. (attention! Concrete should be poured after the house is completely assembled.) 1. SIDe elemeNtS Lay all of the parts on the floor and connect them loosely. ing of greenhouses. Please stick the greenhouse model label pro-vided onto the door bar (1362) after success-fully assembling this product. This information is important in the event that replacement parts are later required. Please keep these Assembly Instructions in a safe place, for future reference! Our policy is one of continuous improvement This means there might be differences between the version found here, and the printed version that followed with your greenhouse. Halls Altan Halls Atrium 7. The greenhouse must always be anchored. EN 011.01.2007 SITE SELECTION Always try to select a sunny location, sheltered from the wind as much as possible. IMPORTANT Before assembling your new greenhouse, please check that all parts in the provided list are included. Please take each bundle out of the packaging in order to identify the parts 4. It is recommended that this greenhouse is assembled by two people. 5. Should you encounter difficulties constructing this house, or in fitting the glass or polycarbonate sheets, please contact your retailer - do not use force! 6. The greenhouse must